Program a remote control opener of a garage wall panels is a task that can be completed in less than half an hour with a minimum of tools. Replace a lost remote control or add one to a new driver is a couple of reasons you need to program a remote control garage. Many new cars have remote controls for garage doors built and can be programmed to work with your specific garage door.
Use the stairs to get a closer look of the garage wall panels. Search an antenna out of this or a button that says “Learn”. This may also be under cover of the opener. Remove the cover to look under it. This usually requires no tools. If you do not find any buttons or antenna under the covers, looking at an alternative location. Some openers have an external receiver.
Program the receiver. Press the “Learn” button. A small light at or near the button should light. You have thirty seconds from this moment to program the remote control in garage wall panels. Hold down the control button. Release it when you have seen the light started flashing opener. Replace the cover on the starter or the external receiver. Test the remote control.